Pl do the following things and align the dish as I told.
Home cast (5202 & 5203):
1.Step 1: Go to Menu and select “Installation” option. 2.Step 2: Select “Manual Scan” and press OK on the remote. 3.Step 3: Pop up window display on the screen “Enter PIN Code” default password is “0000” 4.Step 4: “Manual Scan setting” menu option below Dish – Don’t change Frequency (MHz) – Need Change Polarity – Need Change Symbol rate (Msym/s) – Need Change Modulation – Don’t change Pilot – Don’t change Code Rate – Don’t change Scan Mode – Don’t change Service Type – Don’t change Network Search – Don’t change
5.Step 5: Enter the all “New downlink parameters” using Numeric key on the remote. 6.Step 6: In this Menu see the “Signal Status” and “Signal Strength” levels. 7.Step 7: Press “OK” key on the remote for “Search” all channels 8.Step 8: After scanning its shows “Do you want to save changes” select “Yes” and press Exit. Note: After satellite Migration don’t do Factory default, if customer did kindly follow the same Manual Tuning steps again.
thanks veeramai, your tips helped me alot to align SD into new position, what a simple thing, but these SD people comes means they will get minimum 200 for this alignment, anyway broadcast it for more people let them enjoy. keep it up, all the best. with regards Sathish
good attempt veeramani.... வாழ்த்துக்கள்...!!!
ReplyDeleteThanks sappa figuru!!
ReplyDeleteSir my STB is Home cast how to change tp in this STB
ReplyDeletePl do the following things and align the dish as I told.
ReplyDeleteHome cast (5202 & 5203):
1.Step 1: Go to Menu and select “Installation” option.
2.Step 2: Select “Manual Scan” and press OK on
the remote.
3.Step 3: Pop up window display on the screen “Enter PIN
Code” default password is “0000”
4.Step 4: “Manual Scan setting” menu option below
Dish – Don’t change
Frequency (MHz) – Need Change
Polarity – Need Change
Symbol rate (Msym/s) – Need Change
Modulation – Don’t change
Pilot – Don’t change
Code Rate – Don’t change
Scan Mode – Don’t change
Service Type – Don’t change
Network Search – Don’t change
5.Step 5: Enter the all “New downlink parameters” using Numeric key on the remote.
6.Step 6: In this Menu see the “Signal Status” and “Signal Strength” levels.
7.Step 7: Press “OK” key on the remote for “Search” all channels
8.Step 8: After scanning its shows “Do you want to save changes” select “Yes” and press Exit.
Note: After satellite Migration don’t do Factory default, if customer did kindly follow the same Manual
Tuning steps again.
thank you.........really helpful information...
ReplyDeletei called you today afternoon and got it corrected within an hour.I am from madras......
thanks veeramai, your tips helped me alot to align SD into new position, what a simple thing, but these SD people comes means they will get minimum 200 for this alignment, anyway broadcast it for more people let them enjoy. keep it up, all the best.
ReplyDeletewith regards
Sathish